Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Intake Manifold Cover - Remove - Intake Manifold Cover Replacement
Remove the outer fuel pump insulator (2). Fuel Pump Insulator Replacement (Inner) , or Fuel Pump Insulator Replacement (Outer)
Power Brake Booster Vacuum Hose (1)@Vacuum Pump - Disconnect - Power Brake Booster Vacuum Hose Replacement (LTG)
Retainer (1)@Vacuum Pump (2) - Disconnect
- Electrical Connector (3)@Engine Coolant Temperature Sensor - Disconnect
- Electrical Connector (4)@Camshaft Position Sensor - Disconnect
Vacuum Pump Bolt (1) - Remove [2x]
- Vacuum Pump Bolt (2) - Remove
- Vacuum Pump (3) - Remove
- Vacuum Pump Gasket (4) - Remove and DISCARD
- Inspect the vacuum pump seal in the camshaft cover and replace it if damage is found. Camshaft Cover and Compressor Air Intake Turbocharger Cleaning and Inspection