Right Cylinder Head Intake Face
WARNING: This page is about a different variant/trim than selected.
 Courtesy of GENERAL MOTORS COMPANY
|
Right Cylinder Head Intake Face
| Hole Location |
Thread Size |
Drill |
Counter Bore Tool |
Stop Collar |
Tap |
Driver |
Insert |
Drill Depth (Maximum) |
Tap Depth (Minimum) |
| EN-42385 - |
MM |
(IN) |
MM |
(IN) |
| 1 |
M6 x1.0 |
201 |
202 |
N/A |
203 |
204 |
63 |
23.0 |
.907 |
23.0 |
.907 |
| 2 |
M8 x 1.25 |
206 |
207 |
N/A |
208 |
209 |
61 |
29.0 |
1.14 |
29.0 |
1.14 |