Engine Block Left Face
WARNING: This page is about a different variant/trim than selected.
Engine Block Left Face
| Hole Location | Thread Size | Drill | Counter Bore Tool | Stop Collar | Tap | Driver | Insert | Drill Depth (Maximum) | Tap Depth (Minimum) | ||
|---|---|---|---|---|---|---|---|---|---|---|---|
| EN-42385 - | MM | (IN) | MM | (IN) | |||||||
| 1 | M6 x 1.0 | 210 | 202 | N/A | 203 | 204 | 205 | 18.0 | .709 | 18.0 | .709 |
| 2 | M8 x 1.25 | 206 | 207 | N/A | 208 | 209 | 61 | 29.0 | 1.14 | 29.0 | 1.14 |
| 3 | M10 x 1.5 | 211 | 212 | N/A | 213 | 214 | 215 | 34.0 | 1.35 | 34.0 | 1.35 |
| 4 | M12 x 1.75 | 856 | 857 | N/A | 858 | 859 | 416 | 23.0 | .905 | 23.0 | .905 |