Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
NOTE:
This procedure is required when the following component has been repaired, replaced, removed, or serviced:
- Control Valve Body
- K71 Transmission Control Module
- T12 Automatic Transmission Assembly
- Q77 Transmission Control Solenoid Valve
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P27A7, P27A8, P27A9, P27AA, P27AB, P27AC, P27AD, P27AE is not set.
- If any of the DTCs are set
- Go to next step: If no DTC is set
- All OK.