Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify the correct adjustment: Range Selector Lever Cable.
- If not adjusted correctly
Refer to: Range Selector Lever Cable Adjustment
- Go to next step: If adjusted correctly
- If not adjusted correctly
- Ignition = On
- Transmission - Park
- Verify the scan tool parameter: Park/Neutral Position Switch = Park/Neutral Position Switch
- If not correct
Refer to: Circuit/System Testing
- Go to next step: If correct
- If not correct
- Verify the scan tool parameter: 9V Reference 1 Circuit Status = OK
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- Verify the scan tool parameter: Internal Mode Switch - Voltage
Refer to: Transmission Internal Mode Switch Voltage
- If not correct
Refer to: Circuit/System Testing
- Go to next step: If correct
- If not correct
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.