Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify the scan tool parameter: 9V Reference 1 Circuit Status = OK
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- Road test the vehicle.
- Verify the scan tool parameter: Transmission Intermediate Speed Sensor = The value should change smoothly and gradually as the vehicle speed is increased and decreased.
- If the value does not change smoothly and gradually
Refer to: Circuit/System Testing
- Go to next step: If the value changes smoothly and gradually
- If the value does not change smoothly and gradually
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data. Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.
WARNING:
Road test a vehicle under safe conditions and while obeying all traffic laws. Do not attempt any maneuvers that could jeopardize vehicle control. Failure to adhere to these precautions could lead to serious personal injury and vehicle damage.