LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Automatic Transmission - 8L45 (M5T) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0815, P0816, P0826, or P1876 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: S2 Transmission Manual Shift Switch
  3. Test for 6, 000 to 6, 200 ohms between the test points: Signal terminal 3 & Ground terminal 2
    • If not between 6, 000 and 6, 200 ohms 

      Replace the component: S2 Transmission Manual Shift Switch

    • Go to next step: If between 6, 000 and 6, 200 ohms 
  4. Operate the component: S3 Transmission Shift Lever = Forward
  5. Test for 600 to 700 ohms between the test points: Signal terminal 3 & Ground terminal 2
    • If not between 600 and 700 ohms 

      Replace the component: S2 Transmission Manual Shift Switch

    • Go to next step: If between 600 and 700 ohms 
  6. Operate the component: S3 Transmission Shift Lever = Rearward
  7. Test for 1900 to 2100 ohms between the test points: Signal terminal 3 & Ground terminal 2
    • If not between 1900 and 2100 ohms 

      Replace the component: S2 Transmission Manual Shift Switch

    • Go to next step: If between 1900 and 2100 ohms 
  8. All OK.
scientia non olet · About LEMON Manuals