LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls And Fuel - 3.6L (LGX) - Diagnostic Information And Procedures (P0010 - P0455)) >> Diagnostic Information and Procedures >> DTC P0231, P0232, or P023F (without NPP) >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle & All vehicle systems - Off
  2. Disconnect the electrical connector: K111 Fuel Pump Driver Control Module
  3. Connect a DMM, set on the diode setting, between the test points:
    • Red lead@Low Reference terminal 16
    • Black lead@Ground terminal 9
  4. Verify the DMM displays between 0. 4 and 0. 8 V.
    • If not between 0. 4 and 0. 8 V 

      Replace the component: K111 Fuel Pump Driver Control Module

    • Go to next step: If between 0. 4 and 0. 8 V 
  5. Connect a DMM, set on the diode setting, between the test points:
    • Red lead@Ground terminal 9
    • Black lead@Low Reference terminal 16
  6. Verify the DMM displays the following: O. L.
    • If not the specified value 

      Replace the component: K111 Fuel Pump Driver Control Module

    • Go to next step: If the specified value 
  7. All OK.
scientia non olet · About LEMON Manuals