LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls And Fuel - 3.6L (LGX) - Diagnostic Information And Procedures (P0010 - P0455)) >> Diagnostic Information and Procedures >> DTC P0201-P0206, P0261, P0262, P0264, P0265, P0267, P0268, P0270, P0271, P0273, P0274, P0276, P0277, P2147, P2148, P2150, P2151, P2153, P2154, P2156, P2157, P216B, P216C, P216E, or P216F >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Engine running.
  2. Verify the scan tool parameter:
    • Cylinder 1 Injector Control Circuit Status = OK
    • Cylinder 2 Injector Control Circuit Status = OK
    • Cylinder 3 Injector Control Circuit Status = OK
    • Cylinder 4 Injector Control Circuit Status = OK
    • Cylinder 5 Injector Control Circuit Status = OK
    • Cylinder 6 Injector Control Circuit Status = OK
    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  5. All OK.