Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0010, P0013, P0020, P0023, P2088 - P2095
- Camshaft Position Actuator Solenoid Valve = On
- Ignition Switch Position = Run/Crank
- Ignition Voltage = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met
P0011, P0014, P0021, P0024
- DTC P0010, P0013, P0020, P0023, P2088, P2089, P2090, P2091, P2092, P2093, P2094, P2095 = Not set
- Camshaft Position Actuator Solenoid Valve = On
- Camshaft Position & Desired Camshaft Position = 5 to 20°
- Desired Camshaft Position = Does not vary greater than 4. 5° - For greater than 1 s
- Engine = Running
- Ignition Voltage = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met