Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- NOTE:
The new replacement wiring harness may not have electrical connector (2). It will be a one piece harness.
Install automatic transmission control wiring harness (4).
- If necessary, install the control valve body to the transmission. Control Valve Body Replacement
- Connect the wiring harness clips to the valve body and case.
- Connect the transmission control wiring harness connectors.
- If equipped, ensure the valve body connector retainer (3) is latched.
-
Fig 1: Exploded View Of Transmission Fluid Pan, Filter, Filter Seal, Gasket And Bolts With Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY
Install the transmission fluid filter (4). Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement .