LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 8L45 (M5T) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Manual Shift Shaft Position Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the automatic transmission range selector lever. Refer to Automatic Transmission Range Selector Lever Replacement (M5T) .
  2. Remove the control valve body. Refer to Control Valve Body Replacement .
  3. GM3817211Courtesy of GENERAL MOTORS COMPANY

    Remove and Discard the manual shift shaft detent lever hub pin (3).

  4. Remove and Discard the manual shift shaft pin (1).
  5. Remove the manual shift shaft (2).
  6. Remove or reposition the manual shift shaft position switch assembly as necessary.
  7. GM3817350Courtesy of GENERAL MOTORS COMPANY

    Disconnect the park pawl actuator rod (2) from the manual shift shaft position switch (1).

scientia non olet · About LEMON Manuals