Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the control valve body from the transmission. Refer to Control Valve Body Replacement .
Disconnect the electrical connector (1).
- CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
Remove the input and output speed sensor wiring harness bolts and Discard (1).
- Disconnect the input and output speed sensor wiring harness retainers (4).
- Remove the automatic transmission input and output speed sensor wiring harness (3) from the transmission.