Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Front Brake Hose - Install
Brake Hose Fitting Gasket (1) @ Front Brake Hose (2) - Install NEW [2x]
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Brake Hose Fitting Bolt (1) - Install and tighten 40 N.m (30 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Brake Hose Bracket Bolt (1) - Install and tighten 10 N.m (89 lb in)
Courtesy of GENERAL MOTORS COMPANY

Wheel Speed Sensor Harness Clip (1) @ Brake Hose - Secure [2x]
Courtesy of GENERAL MOTORS COMPANY

Brake Hose Retainer (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Remove cap from brake pipe fitting.
Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
Bleed the brake system. Hydraulic Brake System Bleeding (Manual J55, J6G) , or Hydraulic Brake System Bleeding (Pressure J55, J6G)
Front Wheelhouse Splash Shield - Install - Front Wheelhouse Splash Shield Replacement
Install the tire and wheel assembly. Tire and Wheel Removal and Installation