Rear Compartment Lid Strut Replacement

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury. CAUTION: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result. Preliminary Procedure Rear Body Structure Stop Lamp Trim Panel Replacement
1	Rear Compartment Lid Strut Procedure Release the locking tabs on the strut. Ensure the clip is fully seated when the strut is installed. If the clip cannot be fully seated, install a NEW strut.

Callout

Component Name

WARNING:

When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

CAUTION:

Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.

Preliminary Procedure Rear Body Structure Stop Lamp Trim Panel Replacement

Rear Compartment Lid Strut

Procedure

Release the locking tabs on the strut.
Ensure the clip is fully seated when the strut is installed. If the clip cannot be fully seated, install a NEW strut.