Circuit/System Verification

Ignition ON.
Verify the accent lamps for the components listed below, if equipped, dim from LOW to HIGH while operating the dimmer switch from LOW to HIGH.
- E1AA Floor Accent Lamp - Left Front
- E1AB Floor Accent Lamp - Right Front
- E38 Flood Lamp - Center Console
- E63D Flood Lamp - Driver Door Handle
- E63P Flood Lamp - Passenger Door Handle
- If the accent lamps do not dim from LOW to HIGH
  Refer to Circuit/System Testing - Interior Accent Lighting Malfunction.
- Go to next step: If the accent lamps dim from LOW to HIGH
Verify the accent light pipes for the components listed below, if equipped, turn ON and OFF when commanding the Accent Lighting 2 ON and OFF with a scan tool.
- E1AC Accent Lamp - Center Console Cupholder
- E1D Accent Lamp - Driver Door
- E1P Accent Lamp - Passenger Door
- P17 Info Display Module
- If the accent light pipes do not turn ON and OFF
  Refer to Circuit/System Testing - Interior Accent Light Pipes Malfunction.
- Go to next step: If the accent light pipes turn ON and OFF
Verify the accent light pipes for the components listed below, if equipped, change colors and animation modes while operating the color/mode selection switches.
- E1AC Accent Lamp - Center Console Cupholder
- E1D Accent Lamp - Driver Door
- E1P Accent Lamp - Passenger Door
- P17 Info Display Module
- If the accent light pipes do not change colors or modes
  Refer to Circuit/System Testing - Interior Accent Light Pipes Color/Mode Malfunction.
- Go to next step: If the accent light pipes change colors and modes
All OK.