Ignition Coil Installation (L5Q)

WARNING: This page is about a different car, the 2019 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Inspect the inside of the ignition coil rubber boot for a thin, even coat of grease. If there is no grease present or additional grease is necessary, apply a thin coating of dielectric grease evenly to the inside of the ignition coil rubber boot, up to a depth of 15 mm from the end of the boot. Refer to Adhesives, Fluids, Lubricants, and Sealers (Europe LV7) , or Adhesives, Fluids, Lubricants, and Sealers (Europe L5Q) , or Adhesives, Fluids, Lubricants, and Sealers (North America LV7) , or Adhesives, Fluids, Lubricants, and Sealers (North America L5Q) . Remove any excess grease from around the end of the boot, and ensure there is not an excessive amount within the boot.
1	Ignition Coil [3x]
2	Ignition Coil Bolt[3x] CAUTION: Refer to Fastener Caution . Tighten 10 N. m (89 lb in)

Callout

Component Name

Preliminary Procedure

Inspect the inside of the ignition coil rubber boot for a thin, even coat of grease.
If there is no grease present or additional grease is necessary, apply a thin coating of dielectric grease evenly to the inside of the ignition coil rubber boot, up to a depth of 15 mm from the end of the boot. Refer to Adhesives, Fluids, Lubricants, and Sealers (Europe LV7) , or Adhesives, Fluids, Lubricants, and Sealers (Europe L5Q) , or Adhesives, Fluids, Lubricants, and Sealers (North America LV7) , or Adhesives, Fluids, Lubricants, and Sealers (North America L5Q) .
Remove any excess grease from around the end of the boot, and ensure there is not an excessive amount within the boot.

Ignition Coil [3x]

Ignition Coil Bolt[3x]

CAUTION:

Refer to Fastener Caution .

Tighten
10 N. m (89 lb in)