Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Install the engine lift rear bracket (2).
Install the engine lift rear bracket bolts (1) and tighten to 25 N.m (18 lb ft).
Courtesy of GENERAL MOTORS COMPANY

Install the engine wiring harness bracket (2) and bolt (1).
Tighten to 9 N.m (80 lb in).
Courtesy of GENERAL MOTORS COMPANY

Install the wiring harness retainer (1, 2, 3) to engine wiring harness bracket.
Close the hood.