Sunroof/Sunshade Motor Initialization
WARNING: This page is about a different car, the 2018 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform the initialization/teach procedure on a reinstall motor or a new motor. Ensure the electrical harness on the headliner is connected to the sunroof motor, battery power is applied, and the ignition switch is ON.
Initialization/Teach Procedure
- The sunroof switch must be held during the initialization/teach procedure.
- Press the "manual close switch" for more than 15 seconds after closing the sunroof window fully and until the sunroof window has automatically reached the tilt-up position.
- Open the sunroof window/sunshade with the "express or manual open switch" to the full open position, then release the switch.
- Press the "manual open switch" for more than 15 seconds until the sunroof window is automatically closed and the tilt-up/down is reached.
If the initialization/teach procedure is not carried out completely, the sunroof motor will not work normally and the procedure must be restarted.