Sunroof Window Height and Opening Fit Adjustment
WARNING: This page is about a different car, the 2018 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
- Cycle the sunroof window from full open to closed position.
- NOTE:
Do Not remove or lower headliner to access sunroof window screws.
Loosen the adjusting screws on the window.
- Adjust the corners of the front window panel using the following guidelines:
- Adjust the front of the sunroof window to 0.0 mm - 1.0 mm (0.0 in - 0.04 in) below the top surface of the roof panel.
- Adjust the rear center line of the sunroof window to 2 mm to 3 mm (0.08 in to 0.12 in) below the top surface of the roof panel.
- Tighten the sunroof window adjustment screws to 4 N.m (35 lb in).
- Cycle sunroof window through all positions.
- Inspect the sunroof window adjustment. Adjust if necessary.
NOTE:
Correct adjustment cannot be achieved if the sunroof window is closed from vent position.
CAUTION:
Refer to Fastener Caution .