Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Release the tension using the suitable tool.
Fig 1: Exploded View Of Oil Pump, Bolts And Gaskets/Seals
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Oil pump is removed/installed as an assembly with the oil pump sprocket.

Install the oil pump (2) with 2 oil pump gasket (3).

CAUTION:

Refer to Fastener Caution .

NOTE:

Tighten the bolts in crisscross sequence.

Tighten the oil pump bolts (1) in crisscross sequence to 25 N.m (18 lb ft).
Tighten the oil pump bolts (4) in crisscross sequence to 10 N.m (89 lb in).
Courtesy of GENERAL MOTORS COMPANY

Install the crankshaft oil deflector (3).

NOTE:

Tighten the bolts in crisscross sequence.

Install the 3 crankshaft oil deflector bolts (1) and tighten to 10 N.m (89 lb in).
Install the 2 crankshaft oil deflector bolts (2) and tighten to 25 N.m (18 lb ft).
Courtesy of GENERAL MOTORS COMPANY

Install the oil pump drive chain cover (2) and tighten to 10 N.m (89 lb in).
Install the oil pan. Refer to Oil Pan Replacement (L5Q) .