Assembly Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Engine Support Fixture Assembly Components
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Pre-assemble special tool assembly outside the vehicle.

Install the lower foot (6) to the upper foot (5).
Install the mounting bolt (3).
Install the fixing pin (4).
Install the washer (2) and tighten the nut (1).
Courtesy of GENERAL MOTORS COMPANY

Install the 2 EN-28467-300 adapters to the EN-51007-1 adapter.
Courtesy of GENERAL MOTORS COMPANY

Install the 2 EN-51007-4 adapters to the EN-51007-1 adapter by guiding the bail (4) into the board (1).
Install the 2 thumb nuts (2).
Courtesy of GENERAL MOTORS COMPANY

Install the bushing (1) to the hook (3).
Install the lever (2) to the hook (3).
Courtesy of GENERAL MOTORS COMPANY

Install the EN-51007-6 adapters (1) to the EN-51007-3 adapters (2).
Courtesy of GENERAL MOTORS COMPANY

Install the foot (4) to the rod (2).
Install and tighten the bolt (5) and the nut (3).
Install the bolt (1).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The feet should stay in the second hole of the rakes.

Install EN-51007-5 adapter (3) to the EN-51007-3 adapter (1).
Install the cotter pin (4) into the bolt (2).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The distance (a) must be aligned to 1425 mm (56 in).

Check the distance between the 2 feet (1).