Removal Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Remove the camshaft cover. Refer to Camshaft Cover Replacement .
Courtesy of GENERAL MOTORS COMPANY

Adjust the engine to cylinder 1 top dead center (TDC) of combustion stroke. Set crankshaft in direction of engine rotation until the markings (1, 2) line up. Rotate at the crankshaft balancer bolt (3).
Courtesy of GENERAL MOTORS COMPANY

Install the EN-51632 camshaft locking tool (1).
Remove the engine front cover. Refer to Engine Front Cover Replacement (L5Q) .
Courtesy of GENERAL MOTORS COMPANY

Release the tension by pushing the tensioner and insert the EN-49073 timing chain tensioner pin (1) to the timing chain tensioner (2).
Courtesy of GENERAL MOTORS COMPANY

Remove the timing chain tensioner bolts (1) and timing chain tensioner (2) with timing chain tensioner gasket (3).
Fig 1: Identifying Timing Chain Tensioner Shoe, Timing Chain Guides And Bolts
Courtesy of GENERAL MOTORS COMPANY

Remove the timing chain tensioner shoe bolt (1) and remove the timing chain shoe (2).
Remove the 3 timing chain guide - exhaust side bolts (3) and remove the timing chain guide - exhaust side (4).
Remove the 2 timing chain guide - cylinder side bolts (5) and remove the timing chain guide - cylinder side (6).
Courtesy of GENERAL MOTORS COMPANY

Remove the camshaft timing chain (1).