LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Volt Premier >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Engine Mechanical - 1.0L (L5Q) Or 1.4L (LV7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Flex Plate Replacement

Automatic Transmission Flex Plate Replacement

WARNING: This page is about a different car, the 2018 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Automatic Transmission Flex Plate And Bolts With Tightening Sequence
GM4121413Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the automatic transmission. Refer to Transmission Replacement .
  2. Install EN-652  holder EN-652  , lock the flywheel via the starter ring gear.

Special Tools

  • EN-652  Flywheel Holder
  • EN-45059  Angle Meter
Equivalent regional tools: Special Tools
1 Automatic Transmission Flex Plate Bolt (Qty: 8)
CAUTION:

Refer to Fastener Caution .

CAUTION:

Refer to Torque-to-Yield Fastener Caution .


Tighten the NEW flywheel bolts in the sequence shown.

Procedure

  1. Tighten the bolts a first pass to 20 N.m (15 lb ft).
  2. Tighten the bolts a second pass to 30 N.m (22 lb ft).
  3. Using the EN-45059  angle meter, tighten the bolt a final pass 70 degrees.
  4. Remove EN-652  holder once final torque is achieved.
NOTE:

Bolts have adhesive patch and must be tightened to final torque within 5 minutes.
2 Automatic Transmission Flex Plate
scientia non olet · About LEMON Manuals