Camshaft Cover Components Removal

WARNING: This page is about a different car, the 2019 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Positive Crankcase Ventilation Valve Bolt[2x] Procedure NOTE: Discard the bolt. Using a suitable tool, cut a slot in the tamper-resistant positive crankcase ventilation valve bolt head. Remove the bolt with a flat-bladed tool and discard.
2	Positive Crankcase Ventilation Tube with Positive Crankcase Ventilation Valve NOTE: Discard the tube and valve.
3	Positive Crankcase Ventilation Tube with Positive Crankcase Ventilation Valve NOTE: Discard the tube and valve.
4	Camshaft Position Sensor Bolt
5	Intake Camshaft Position Sensor
6	Camshaft Position Sensor Bolt
7	Exhaust Camshaft Position Sensor
8	Vacuum Pump Seal Special Tools EN-51096 Seal Remover Equivalent regional tools: Special Tools .
9	Camshaft Cover Locating Pin [2x]
10	Camshaft Position Actuator Solenoid Valve Bolt
11	Camshaft Position Actuator Solenoid Valve
12	Camshaft Position Actuator Solenoid Valve Bolt
13	Camshaft Position Actuator Solenoid Valve