Component Testing

Instrument Panel Compartment Door Release Switch

1. Ignition OFF, disconnect the harness connector at the S48D Multifunction Switch 2 - Instrument Panel.
2. Test for infinite resistance between the signal terminal 7 and the ground terminal 1 with the switch in the open position.
   • If less than infinite resistance 

     Replace the S48D Multifunction Switch 2 - Instrument Panel.

   • Go to next step: If infinite resistance 
3. Test for less than 3 Ω between the signal terminal 7 and the ground terminal 1 with the switch in the closed position.
   • If 3 Ω or greater 

     Replace the S48D Multifunction Switch 2 - Instrument Panel.

   • Go to next step: If less than 3 Ω 
4. All OK.

Instrument Panel Compartment Door Release Actuator

1. Ignition OFF, disconnect the harness connector at the M91 Instrument Panel Compartment Door Unlatch Actuator.
2. Install a 10 A fused jumper wire between the control terminal 1 and 12 V. Install a jumper wire between the ground terminal 2 and ground.
3. Verify the M91 Instrument Panel Compartment Door Unlatch Actuator activates.
   • If the M91 Instrument Panel Compartment Door Unlatch Actuator does not activate. 

     Replace the M91 Instrument Panel Compartment Door Unlatch Actuator.

   • Go to next step: If the M91 Instrument Panel Compartment Door Unlatch Actuator does activate. 
4. All OK.