Circuit/System Verification
- Ignition - On / Vehicle - In Service Mode
- Verify the scan tool parameter : Engine Oil Pressure = 0 kPa (0 PSI)
- If not the specified state
Refer to: Circuit/System Testing .
- Go to next step : If the specified state
- If not the specified state
- Verify the engine has the correct oil level and the correct oil pressure before continuing with this diagnostic.
- Engine Running
- Verify the scan tool parameter : Engine Oil Pressure = CH-48027 Digital Pressure Gauge
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step : If the specified state
- If not the specified state
- Verify the scan tool parameter : V = Engine Oil Pressure - Gauge @ P16 Instrument Cluster
- If not the specified state
Test or replace the component : P16 Instrument Cluster
- Go to next step : If the specified state
- If not the specified state
- All OK.