LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Spark ACTIV, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 1.0L (L5Q) Or 1.4L (LV7) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

  1. Remove the crankshaft position sensor reluctor ring. Refer to Crankshaft Position Sensor Reluctor Ring Replacement , or Crankshaft Position Sensor Reluctor Ring Replacement (LV7) .
  2. GM4003981Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The engine could be equipped with two different rear oil seal designs.

    Check which of the crankshaft rear oil seals (1, 2) is installed.

  3. GM3701652Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Be careful that the crankshaft will not be damaged while the crankshaft rear oil seal is pulled out. Failing to do so may reduce the leak-tightness and could cause damage to the crankshaft.

    Use a suitable tool to remove the seal.

  4. Remove the Crankshaft Rear Oil Seal (1) from the Crankshaft.
scientia non olet · About LEMON Manuals