Oil Pan Installation (L5Q)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Oil Pan Procedure Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant NOTE: All sealing surfaces must be free of contamination prior to applying the sealer. Installation and final torque specification must be completed within 10 minutes of applying the sealant. Additional sealant is necessary to reduce the possibility of leakage where the cylinder head to engine block interface along the bead path flange on the front cover. Apply a 3 mm bead of sealer around the perimeter of the oil pan. Refer to Adhesives, Fluids, Lubricants, and Sealers (Europe LV7) , or Adhesives, Fluids, Lubricants, and Sealers (Europe L5Q) , or Adhesives, Fluids, Lubricants, and Sealers (North America LV7) , or Adhesives, Fluids, Lubricants, and Sealers (North America L5Q) . Install the oil pan on the lower crankcase, ensure the oil pan locating pins align with the lower crankcase.
2	Oil Pan Bolt[9x] CAUTION: Refer to Fastener Caution . NOTE: Hand start the oil pan bolts. Torque to specification when all oil pan bolts are installed hand-tight. Tighten 10 N. m (89 lb in)
3	Oil Pan Bolt[4x] NOTE: Inspect for excessive sealer around the oil filter mounting area when final torque is achieved. If extra sealer is present, remove and clean accordingly. Procedure Tighten the bolts in sequence. Tighten the bolts a first pass to 5 N. m (44 lb in) Tighten the bolts a final pass to final torque specification. Tighten 10 N. m (89 lb in)

Callout

Component Name

Oil Pan

Procedure

Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant

NOTE:

All sealing surfaces must be free of contamination prior to applying the sealer.
Installation and final torque specification must be completed within 10 minutes of applying the sealant.
Additional sealant is necessary to reduce the possibility of leakage where the cylinder head to engine block interface along the bead path flange on the front cover.

Apply a 3 mm bead of sealer around the perimeter of the oil pan. Refer to Adhesives, Fluids, Lubricants, and Sealers (Europe LV7) , or Adhesives, Fluids, Lubricants, and Sealers (Europe L5Q) , or Adhesives, Fluids, Lubricants, and Sealers (North America LV7) , or Adhesives, Fluids, Lubricants, and Sealers (North America L5Q) .
Install the oil pan on the lower crankcase, ensure the oil pan locating pins align with the lower crankcase.

Oil Pan Bolt[9x]

CAUTION:

Refer to Fastener Caution .

NOTE:

Hand start the oil pan bolts. Torque to specification when all oil pan bolts are installed hand-tight.

Tighten
10 N. m (89 lb in)

Oil Pan Bolt[4x]

NOTE:

Inspect for excessive sealer around the oil filter mounting area when final torque is achieved. If extra sealer is present, remove and clean accordingly.

Procedure
Tighten the bolts in sequence.

Tighten the bolts a first pass to 5 N. m (44 lb in)
Tighten the bolts a final pass to final torque specification.

Tighten
10 N. m (89 lb in)