LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Spark ACTIV, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 1.0L (L5Q) Or 1.4L (LV7) - Repair Instructions - Off Vehicle >> Repair Instructions - Off Vehicle >> Cylinder Head Installation (L5Q)

Cylinder Head Installation (L5Q)

GM3973933Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Cylinder Head Gasket
NOTE:

Ensure that the cylinder head and the engine block sealing surfaces are clear of oil, grease, and old gasket material.
2 Cylinder Head
3 Cylinder Head Bolt [8x]
CAUTION:

Refer to Fastener Caution .

CAUTION:

Refer to Torque-to-Yield Fastener Caution .


Procedure 
Tighten the NEW cylinder head bolts in the sequence shown.
  1. Tighten the bolts a first pass to 30 N. m (22 lb ft).
  2. Using the EN-45059  angle meter, tighten the bolts a final pass to 240 degrees.

Special Tools 
EN-45059  Angle Meter
Equivalent regional tools: Special Tools .
4 Camshaft Bearing Lower Cap
scientia non olet · About LEMON Manuals