LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Spark ACTIV, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 1.0L (L5Q) Or 1.4L (LV7) - Repair Instructions - Off Vehicle >> Repair Instructions - Off Vehicle >> Crankshaft Front Oil Seal Installation

Crankshaft Front Oil Seal Installation

GM3975802Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Crankshaft Front Oil Seal

Procedure

    NOTE:

    The oil seal must be installed in the correct direction. The side that faces out will have "this side out" printed on it. The design of the seal determines which end of the EN 51368  installer is used. Use the end of the installer that matches the design of the seal, as shown.

  1. Lubricate the outside diameter of the new crankshaft seal with clean engine oil.
  2. Determine which end of the EN-51368  installer will be used and install the seal on it.
  3. Install the EN-51368  installer over the crankshaft.
  4. Install the EN-51368  screw, large washer, bearing, and nut.
  5. Counter-hold the screw, and tighten the nut to install the seal.

Special Tools 
EN-51368  Front Crankshaft Seal Installer
Equivalent regional tools: Special Tools .
scientia non olet · About LEMON Manuals