Automatic Transmission Flex Plate Installation (Europe)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Crankshaft Position Sensor Reluctor Ring
2	Automatic Transmission Flex Plate Procedure Install the flex plate, and install the flex plate bolts hand tight to hold in place. Install EN-652 holder to lock the flywheel via the starter ring gear. Special Tools EN-652 Flywheel Holder Equivalent regional tools: Special Tools .
3	Automatic Transmission Flex Plate Bolt[8x] CAUTION: Refer to Fastener Caution . CAUTION: Refer to Torque-to-Yield Fastener Caution . NOTE: Bolts have adhesive patch and must be tightened to final torque within 5 minutes. Procedure Tighten the NEW flywheel bolts in the sequence shown. Tighten the bolts a first pass to 20 N. m (15 lb ft). Tighten the bolts a second pass to 30 N. m (22 lb ft). Using the EN-45059 angle meter, tighten the bolt a final pass 70 degrees. Remove EN-652 holder once final torque is achieved. Special Tools EN-45059 Angle Meter Equivalent regional tools: Special Tools .

Callout

Component Name

Crankshaft Position Sensor Reluctor Ring

Automatic Transmission Flex Plate

Procedure

Install the flex plate, and install the flex plate bolts hand tight to hold in place.
Install EN-652 holder to lock the flywheel via the starter ring gear.

Special Tools
EN-652 Flywheel Holder
Equivalent regional tools: Special Tools .

Automatic Transmission Flex Plate Bolt[8x]

CAUTION:

CAUTION:

NOTE:

Bolts have adhesive patch and must be tightened to final torque within 5 minutes.

Procedure
Tighten the NEW flywheel bolts in the sequence shown.

Special Tools
EN-45059 Angle Meter
Equivalent regional tools: Special Tools .