Circuit/System Verification
- Verify no DTC is set.
- If any DTC is set
diagnose DTCs first.
- Go to next step: If no DTCs are set
- If any DTC is set
- Ignition ON, perform the Tachometer Gauge Sweep test with the scan tool, verify tachometer sweeps from low to high position.
- If tachometer does not sweep
replace the P16 Instrument Cluster.
- Go to next step: If tachometer sweeps properly
- If tachometer does not sweep
- Engine running, verify the tachometer value matches the Engine Speed parameter on the scan tool.
- If the value does not match
replace the P16 Instrument Cluster.
- Go to next step: If the tachometer value matches the value displayed on the scan tool
- If the value does not match
- Replace the K20 Engine Control Module.