LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Cruze Premier, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Diagnostic Information And Procedures (P057B-P208D)) >> Diagnostic Information and Procedures >> DTC P2081, P2085, P242B, P242E, P2472, or P2484 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On/Vehicle - In Service Mode
  2. Verify the scan tool parameter: Exhaust Gas Temperature Sensor 1, 2, 3 = -39 to 999°C (-38 to 1830°F)
    • If not the specified value 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified value 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  4. All OK.