Repair Instructions
WARNING: This page is about a different variant/trim than selected.
Perform the Diagnostic Repair Verification after completing the repair: Diagnostic Repair Verification
- Exhaust Particulate Sensor Replacement
- For control module replacement, programming, and setup refer to: Control Module References
Additional Procedures
Perform only when the following component is replaced or serviced: B136 Exhaust Particulate Matter Sensor
Observe the scan tool parameter: Diesel Particulate Filter (DPF) Soot Accumulation
- Diesel Particulate Filter (DPF) Regeneration Enable - If less than 100%
- Diesel Particulate Filter (DPF) Service Regeneration - If 100% or greater