Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON, clear the DTC information with a scan tool.
- Verify no other DTCs are set.
- If any other DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- Go to next step: If no other DTCs are set
- If any other DTCs are set
- Verify DTC P10F4 or P20FF is not set.
- If any of the DTCs are set
- Program the K115 Reductant Control Module. Refer to Control Module References .
- Verify DTC P10F4 or P20FF is not set.
- If any of the DTCs are set, replace the K115 Reductant Control Module.
- Go to next step: If none of the DTCs are set
- All OK.