Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P10DA
Run/Crank Circuit Voltage = Low Voltage & Reductant Control Module Supply Voltage = High Voltage
P10DB
Run/Crank Circuit Voltage = High Voltage & Reductant Control Module Supply Voltage = Low Voltage
P10DC
Battery Voltage-Reductant Heater Supply Voltage = Greater than 2 V
P10DD
Reductant Heater Supply Voltage-Battery Voltage = Greater than 2 V
P21CB
Reductant Control Module Supply Voltage = Less than a predefined threshold - For greater than 5 s