Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P10C9
The reductant control module detects that the sensor power supply is less than 4.75 V.
P10CA
The reductant control module detects that the sensor power supply is greater than 5.25 V.
P2ADA, P2ADD
The reductant control module detects a performance fault on the reductant quality sensor temperature signal for greater than 1 s.
P2ADB
The reductant control module detects that the reductant quality sensor temperature signal is out of range low for greater than 1 s.
P2ADC
The reductant control module detects that the reductant quality sensor temperature signal is out of range high for greater than 1 s.