Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON.
- Verify that DTCs P119D, P119E, P119F, P11BE, P11BF, P11C0, P11C7, P11C8, P11D0, P11D1, P11D2, P11D5, P11D8, P11D9, P11DA, P11DC, P11FC, P11FD, P11FE, P22A0, P22A1, P22A3, P22A4, P22A5, P22A6, P22A7, P22A8, P22A9, or P22FE are not set
- If any of the DTCs are set
Replace the B195B Nitrogen Oxides Sensor 2
- Go to next step: If none of the DTCs are set
- If any of the DTCs are set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set
- If the DTC sets
Replace the B195B Nitrogen Oxides Sensor 2
- Go to next step: If DTC does not set
- If the DTC sets
- All OK.