Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Disconnect the appropriate electrical connector: E12 Glow Plug
- Test for 0.3 to 1.0 ohms between the test points: Control terminal 1/A & The component's housing
- If not between 0.3 and 1.0 ohms
Replace the component: E12 Glow Plug
- Go to next step: If between 0.3 and 1.0 ohms
- If not between 0.3 and 1.0 ohms
- All OK.