Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Engine - Running
- Verify the scan tool parameter:
- Fuel Pump Enable Circuit High Voltage Test Status = Not Run/OK
- Fuel Pump Enable Circuit Low Voltage Test Status = Not Run/OK
- Fuel Pump Enable Circuit Open Test Status = Not Run/OK
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.