Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P16A0
The ECM detects a low voltage circuit condition on the throttle position sensor signal circuit for greater than 0.5 s.
P16A1
The ECM detects a high voltage circuit condition on the throttle position sensor signal circuit for greater than 0.5 s.
P16A2
The ECM detects an incorrect message was received over the throttle position sensor signal circuit for greater than 0.5 s.
P02E8
The ECM detects that the throttle valve position sensor voltage is less than a calibrated threshold for 0.5 s.
P02E9
The ECM detects that the throttle valve position sensor voltage is greater than a calibrated threshold for 0.5 s.