Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON.
- Verify the KR75 Engine Controls Ignition Relay clicks when cycling the ignition from OFF to ON.
- If the relay does not click
Refer to Circuit/System Testing
- Go to next step: If the relay clicks
- If the relay does not click
- Verify with a scan tool that DTC P0201B, P0201D, P16F3 or P20F8 are not set.
- If DTC P0201B, P0201D, P16F3 or P20F8 are set
- Go to next step: If DTC P0201B, P0201D, P16F3 or P20F8 are not set
- All OK.