Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON.
- Verify that no other DTCs are set.
- If any other DTCs are set
- Go to next step: If no other DTCs are set
- Verify the conditions listed below do not exist:
- Any damaged exhaust system components
- Loose or improperly installed exhaust system components.
- Restrictions in the exhaust differential pressure sensor ports.
- Damaged, bent, restricted, or kinked exhaust differential pressure lines.
- Induction system leaks.
- Loose or disconnected charge air cooler system components.
- If a condition is found
Repair as necessary
- Go to next step: If no condition is found
- Ignition ON.
- Verify DTC P2459 is not set.
- If the DTC is set
- Perform the Diesel Particulate Filter Service Regeneration.
- Verify the regeneration completed.
- If the regeneration did not complete, replace the Diesel Particulate Filter.
- Go to next step: If the regeneration completed
Go to next step: All OK.
- Go to next step: If no DTC is set
- All OK.