LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Cruze Premier, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Diagnostic Information And Procedures (P208A-P31BF) And Symptoms) >> Diagnostic Information and Procedures >> DTC P244A >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Verify the integrity of the DPF system by visually and physically inspecting any of the following conditions:
    • Any damaged exhaust system components
    • Loose or improperly installed exhaust system components.
    • Restrictions in the exhaust differential pressure sensor ports.
    • Damaged, bent, restricted, or kinked exhaust differential pressure lines.
    • If a condition is found 

      Repair as necessary.

    • Go to next step: If no condition is found 
  2. Remove and inspect the flexible part of the exhaust differential pressure lines for internal restrictions.
    • If any restrictions are found 

      Repair as necessary.

    • Go to next step: If no restrictions are found 
  3. Connect the exhaust port of the EN 23738-A vacuum gauge to port one (engine side) of the B154 Diesel Particulate Filter Exhaust Differential Pressure Sensor.
  4. Ignition ON, using the EN 23738-A vacuum gauge, slowly apply pressure to the sensor while observing the DPF Differential Pressure parameter.
  5. Verify the parameter increases smoothly without spikes or dropouts.
    • If the parameter does not increase smoothly 

      Replace the B154 Diesel Particulate Filter Exhaust Differential Pressure Sensor.

    • Go to next step: If the parameter increases smoothly 
  6. Replace the Diesel Particulate Filter.
scientia non olet · About LEMON Manuals