Torque Converter Housing with Fluid Pump Assembly Installation
WARNING: This page is about a different variant/trim than selected.
Fig 1: Exploded View Of Torque Converter Housing With Fluid Pump Assembly Components With Tightening Sequence
| Callout | Component Name |
|---|---|
| 1 | Front Differential Carrier Bearing |
| 2 | Automatic Transmission Fluid Pump Seal Procedure Install a NEW seal. Do NOT reuse the old seal. |
| 3 | Torque Converter Housing Gasket Procedure Install a NEW gasket. Do NOT reuse the old gasket. |
| 4 | Torque Converter Housing Procedure Rotate the differential slightly in each direction using the rotating tool to align the Differential Pinion Gears with the Differential Ring Gear in the Torque Converter Housing. DT-49938 Differential Rotating Tool Special Tools DT-49938 Differential Rotating Tool Equivalent regional tools: Special Tools |
| 5 | Torque Converter and Differential Housing Bolt [14x]
CAUTION:
Refer to Fastener Caution . Tighten in sequence
|