Control Valve Solenoid Body Wiring Harness Removal

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Control Valve Body Bolt [2x]
2	Control Valve Solenoid Body Bolt
3	Automatic Transmission Wiring Harness Procedure Ensure you disconnect all the connectors from the valve body. On-Vehicle the Variable Feed Solenoid Clutch Accumulator Piston and Spring may fall out. Control Valve Body Assembly Disassemble NOTE: The bolts are captured with harness.
4	Automatic Transmission Wiring Harness Seal Procedure Remove and DISCARD the seal.