1-Reverse and 1-2-3-4-5-6 Clutch Piston Housing Installation
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | 1-Reverse and 1-2-3-4-5-6 Clutch Piston Housing Procedure Make sure lube holes line up properly.
NOTE:
Before Installing 1-Reverse and 1-2-3-4-5-6 Clutch Piston Housing, check for proper operation. The 1-Reverse Backing Plate should spin freely in one direction and lock in the other direction. A slight ratcheting noise may be heard when spinning in the free direction. |