Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- DTCs related to the following system/component = Not Set
- B14A Transmission Output Shaft Speed Sensor
- B14C Transmission Input Shaft Speed Sensor
- B14D Transmission Intermediate Shaft Speed Sensor
- B15 Transmission Internal Mode Switch
- Battery Voltage = Greater than 9 V
- Engine Speed = Greater than 400 RPM
- High Side Driver 1 = On
- High Side Driver 2 = On
- Ignition/Vehicle = On
- Transmission Fluid Temperature = -256 to 130°C (-430 to 266°F)
- Transmission OSS = Greater than 34 RPM
Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 1 s