Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- S3 Transmission Shift Lever = L
- Verify the scan tool parameter: Driver Shift Control Mode Switch @ K9 Body Control Module = On
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- Operate the component: S2 Transmission Manual Shift Switch - +
Verify the scan tool parameter: Up and Down Shift Switch = Up or Upshift
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- Operate the component: S2 Transmission Manual Shift Switch
Verify the scan tool parameter: Up and Down Shift Switch = Down or Downshift
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.